PLEASE NOTE!

If you have a carburettor vespa you need to make a direct connection first! Connect the black yellow wire of the voltage regulator (under the horn) to the white wire of the ignition switch. If you do not do this, the lamp will burn directly through. If you have done this correctly, all lights should go on when turning the ignition switch to the right without starting the scooter. If this is the case, it is safe to mount the lamp. This message is also on a sticker on the lamp!

How do I mount the LED Angeleye on my carburetor vespa?

Using the diagram below you can manually connect the lamp. Make sure you insulate the cables properly.
Yellow : White or Orange Ignition lock
White : Purple H4 Plug
Black : Black H4 Plug
Red : Do not connect

How do I mount the LED Angeleye on my Injection vespa?

Using the diagram below you can manually connect the lamp. Make sure you insulate the cables properly.
Yellow : White or Orange Ignition lock
White : Purple H13 Plug
Black : Black H13 Plug
Red : Do not connect